Blog
Double Leaf Bar Door

Double Leaf Bar Door

Table of Contents

  • What Is a Double Leaf Bar Door?
  • When Is a Double Leaf Needed?
  • Opening Size and Leaf Width
  • Two-Way Traffic and Safety
  • Installation and Adjustment

What Is a Double Leaf Bar Door?

A double leaf bar door is a passage door made of two leaves that divide the opening in the middle; each leaf opens in both directions and returns to centre by itself when released. When closed, the leaves meet in the middle with no fixed centre post between them, so the full width of the opening can be used.

These doors are used between the bar and kitchen, in service corridors of banquet halls and hotel restaurants, and at passages in cafés and restaurants where service trolleys go through.

It works on the same principle as a single leaf bar door; the difference is that it closes a wider opening with two smaller, lighter leaves.

When Is a Double Leaf Needed?

If service trolleys, tray carts or dish carts pass through, the opening becomes wider than a single leaf can comfortably handle. Splitting it into two leaves makes each leaf lighter and easier to push.

If staff are going in and out at the same time during busy periods, double leaves can also be used to separate two-way traffic: one leaf is designated for entry and the other for exit.

Because each leaf is half the width, its swing area is smaller too. This makes a double leaf practical where there is limited space in front of the opening and a single wide leaf would not fit. For narrow passages used only by staff, a single leaf door is usually enough.

Opening Size and Leaf Width

The overall door width should be based on the widest trolley that passes through, plus room for staff passing alongside. If a trolley must pass by opening only one leaf, that leaf should not be narrower than the trolley.

The swing area of each leaf should be checked in both directions. There should be no shelves, counter corners, sockets or wall projections in this area, and the leaf should not hit surrounding equipment when fully open.

Leaf height and bottom clearance should be set with the floor finish behind the door and any level difference in mind. Leaves that drag on the floor wear faster and strain the return mechanism.

Double Leaf Bar Door

Two-Way Traffic and Safety

It is recommended to have a vision panel in each leaf. That way, whichever leaf is used, the person on the other side can be seen and the risk of collision is reduced.

If entry and exit directions are set, they can be shown with simple markings on the leaves. Once staff get used to this arrangement, encounters at the door during busy periods drop noticeably.

The return speed of the two leaves should be set close to each other. Leaves returning at different speeds can clash in the middle or leave a gap when closed. Fitting kick plates to the lower part, which is most affected by trolleys and foot pushing, extends the life of the leaves.

Installation and Adjustment

During installation, both leaves should sit at the same height, parallel to the frame and aligned with each other in the middle. The gap between the leaves should be set so they do not rub, without being larger than necessary.

If one leaf constantly stays slightly open, does not return to centre or does not line up with the other leaf, its hinge adjustment has drifted. In that case both leaves should be readjusted together.

Periodic checks of hinge fixings, vision panels and kick plates are recommended. For door options suited to your passage, you can contact the Imamoğlu team.

Free quote

Get a quote for your project